Battery Uplight
Also includes instructions for Battery Uplight remote control and examples to get the best out of your setup
Step 1:
Unplug cable from each light and remove from transport crate
DO NOT remove cables, powerboard or chargers from crate. These are not needed to operate the battery uplights
Step 2:
Switch on the battery uplight from the rear using the power switch (highlighted in green) Do not touch any of the buttons highlighted in red (These are for advanced users only)
Step 3:
Use the remote control provide to select colours and change functions on the light. Always point the remote at the front of the light
Remote control functions
Black Out
Press once to turn the lights off Press again to turn the lights on
Static colour selection
The selected Single colour will be permanently ON
Press Buttons [0] - [9] to select a single colour
Press buttons [+] & [ - ] to adjust light intensity (default setting is 80%)
DO NOT USE THE [0] SETTING FOR WHITE. (this setting will reduce the battery life to 3 hours)
For White do the following:
Switch the light off at the back panel using the power switch
Switch the light on at the back panel using the power switch
Press the [Manual] button once
Press [W]
Colour Fade Mode
Colours will slowly fade from one to the next
Press [FADE]
Use buttons [+] & [-] to adjust fade speed
Sound Activated Mode
Colours will change with sound / music beat
Press [SOUND]
Use buttons [+] & [ - ] to adjust the sound sensitivity
Colour Flash Mode
Colours will flash from one to the next
Press [AUTO]
Use buttons [+] & [ - ] to adjust flash speed
Strobe Effect Mode
The strobe effect will add a flashing strobe effect to any pre-selcted Mode or Static Colour
There are four flashing speeds
Each time the strobe button is pressed the flashing speed will increase
Creating Custom Colours
Setting for UV, Black Light (Glow in the dark)
Press Black Out
Press the [UV] button 4 times
Setting for White
Press Black Out Press the [W] button 1 to 5 times. each time the brightness will increase Press 1 time - 20% brightness Press 2 times - 40% brightness Press 3 times - 60% brightness Press 4 times - 80% brightness Press 5 times - 100% brightness
Setting Custom Colours (advanced use)
Custom colours may be created using the individual control of the 6 LEDS. R-G-B-W-A-UV
Press [MANUAL] to enter manual mode
Press [R] [G] [B] [A] [UV] [W] buttons to cycle through a 20% intensity change of each colour
Pressing [MANUAL] again will exit manual colour mode, light will blackout.
Battery Life
Static Colours : 6-8 hours Custom Colour White : 8-10 hours Custom Colour UV : 8-10 hours Other Custom colours are dependent on the intensity of each colour used : 3-10 hours
Recharging Batteries
Step 1
Plug in Charging Cable
Step 2
Switch power ON RED light on the charger indicates the light is being charged
Once the panel shows _100, the battery is fully charged The charger light turns GREEN when it stops charging
TIPS FOR THE BEST SETUP EFFECT Some examples to try
Less is more when choosing colours. Try choosing just two colours for a more subtle effect. Try illuminating walls with two alternating colours
Pointing the lights across the floor running down a hallway
Uplights illuminating walls, plants and columns
Last updated